- #DOES ARC SYSTEM 2.5 REALLY WORK HOW TO#
- #DOES ARC SYSTEM 2.5 REALLY WORK DRIVERS#
- #DOES ARC SYSTEM 2.5 REALLY WORK SOFTWARE#
Here, measurements are being taken from positions that describe a three-dimensional volume around the listening position, and the software is using these data points to calculate an accurate response curve. Seven measurements are taken within each layer: one aligned to the listening position, and the others in front and behind that position. Three layers of measurement are used, the first being in the plane of the listening position, the second 15cm below, and the third 15cm above. Thankfully, the software keeps you informed as to exactly where the mic must be placed. This is just as well, as the analysis takes measurements from 21 different positions. Performing an analysis with ARC System 3 is refreshingly simple, with the program leading you through the process from beginning to end.
#DOES ARC SYSTEM 2.5 REALLY WORK HOW TO#
If you have a different measurement mic, you can use it with the analysis software so long as you have a text file that describes the mic’s frequency response, which should be loaded into the software so that it knows how to compensate for that particular mic. Such a mic is available as an optional extra for ARC System 3, and the frequency response curve for this mic is built into the analysis software, as are response curves for older ARC System measurement mics. Of course, the analyser needs to be fed a signal from a suitable measurement mic, and it needs to know that mic’s frequency response in order to properly compensate for it during the analysis. The analyser is used to measure the sound at the listening position, while the correction plug-in, inserted into your DAW’s main mix or monitor output path, uses that measured response to create and apply a corrective EQ curve. One such solution is IK Multimedia’s ARC System, recently upgraded to its third iteration.Īt the heart of the ARC System 3 package are two software components: an analyser application and a correction plug-in. Performing this procedure manually is without doubt a painstaking, fiddly and time-consuming process, which is why many people reach for automated solutions. With the analyser revealing the frequency response at the listening position, you can tune out the inaccuracies using a 1/3-octave graphic EQ (a graphic EQ with more than 30 bands) inserted into the monitor signal path.
This involves playing sounds through the monitors –typically white noise and/or sine waves at specific frequencies – while capturing and analysing the results using a special measurement mic hooked up to a spectrum analyser. There’s a lot to think about.įixing these inaccuracies involves a procedure known as room calibration. The peculiarities of the room and the materials it’s made from will cause some frequencies to be weakened while others are accentuated, and this pattern of sonic colouration will vary depending on your position as a listener.
#DOES ARC SYSTEM 2.5 REALLY WORK DRIVERS#
Your room’s acoustics have almost as much impact on the accuracy of what you hear as the monitor drivers themselves. Accurate monitoring isn’t all about the monitors themselves though.
0 kommentar(er)
